|
================================================== ================
[Concept] The scientific name of the wipers the: wiper WINDSHIELD WIPER wiper is installed on the windscreens on attachments. ================================================== ================ [For use] To remove the windshield to impede the sight of rain, snow and dust ================================================== ================ [Sub class] According to their drive way points Mechanical, vacuum, pneumatic, hydraulic, electric, etc. ================================================== ================ [Specifications] Inch units and metric units control: 14 "- 350mm 16 "- 400mm 18 "- 450mm 20 "- 500mm 21 "- 525mm 22 "- 550mm 24 "- 600mm 26 "- 650mm. That is, size for each additional inch, wiper length of 25mm. ================================================== ================ [Work] An intermittent wiper --- every four seconds, scraping for the drizzle. (2) low-speed wiper --- for rain and snow High-speed wiper --- for the heavy rain, heavy snow. ================================================== ================ Troubleshooting]. Wipers, wiper motor is making abnormal noises, especially the wiper motor was given a "buzzing" sound does not rotate, wipers mechanical transmission part of the rust, or stuck, then should immediately turn off the wipers to prevent burning the motor. If the wiper motor is no abnormal noise, wipers do not work, mostly because the fuse is burned. At this point, just to find the wipers fuse out to insert a new one can be. If there is no dedicated wiper fuse, can also use other objects instead. Chip fuses can be used on other secondary lines fuse to replace the glass tube fuse cigarette box of aluminum foil on the outside glass tube around a few times instead. (3) If a drizzle when the wipers can not be thoroughly brush rain net windshield, wipe uneven traces left on the glass surface, under normal circumstances, this is because the rubber part of the hardening of the wiper, wiper not work with glass face tight fit, or because the rubber on the wipers With injuries caused by uneven wipe on, the formation of residual dirt. At this time the best buy to put a new wiper rubber sheet. If the wipers work, the glass surface was mist, fine drops of water-like, fuzzy stripes or local, which is due to the impact of film, dirt or wax, as long as the windshield and wiper blades clean you can a. 5 If the driving process wipers have problems, do not have wipers or rubber sheet to replace at this time, you can wipe the windshield above the layer of soap, can be maintained for at least 40 minutes a clear line of sight , but also soap smear on the rear window, as the situation improved. If there is no soap, can also be used cigarette butts or find some thicker, more moisture content of the leaves, crush painted above the windshield can still play a role. ================================================== ================ [More change] --------------------- Wiper or wipers replacement of the rubber sheet is very simple, but the replacement should pay attention, model and year, wiper installation methods and different lengths. Some wipers only need to replace the rubber sheet can be. The wiper arm is vertical stand up, if it is shielded not be established, the first glass surface wet, when the wiper motor switch easier to replace the position set at OFF. 2 wiper installation of a U hook, screw-locked. Hook type hook to pull up the wipers can unplug. (3) to take down the wiper is best and the length of the newly installed wiper comparison and to see if the same, and then look at the installation method is the same. The wiper as much as possible according to the original insert it fixed. The windshield wet, observe the movement of the wiper is normal. --------------------- Replacing the wiper arm Wipers with the wiper arm spring forces in close contact with the windshield. When the spring tension is weaker, due to bring the windshield at high speed powerful air pressure leaving the wipers float or hanging in the windshield. In order to completely exclude this fault, it is best to update the entire set of wiper arm. The wiper arm installation portion of the cap removed. (2) fixing nut to loosen and remove. The wiper arm put in the upright state, and then a little movement will fall off. Put in new wiper arm wiper body. 5 in the stop position of the wiper nut Tighten the lid mounted on OK. ================================================== ================ [Electric wiper Consists of motor, crank, drive rod, scraping arm and smear. The motor rotates, driven by the crank and the drive rod, scraping arm together with a smear on the glass ================================================== ================ [No wipers system] With unique smart adaptive spring steel shrapnel dispersed pressure, making the smear part of the balance of power, to avoid the drawbacks of traditional wiper. No wipers pursuit with the perfect combination of aerodynamics, the complete elimination of the car at high speed due to wind movement caused by jitter, so that the smear on the glass wear to a minimum. Designed to be simple, small structure, a very light weight, but also makes the car's windshield wiper motor life expectancy more than 2 times; Replace the wiper arm not only the replacement of the original car the traditional skeleton wiper blades can be more economical and more convenient. ================================================== 【Article is excerpted from: Baidu Encyclopedia】 |
|
|
来自： LOFT生活 > 《Home Topics》
