路由器显示命令 router#show run 显示配置信息 router#show interface 显示接口信息 router#show ip route 显示路由信息 router#show cdp nei 显示邻居信息 router#reload 重新起动 路由器口令设置 router>enable 进入特权模式 router#config terminal 进入全局配置模式 router(config)#hostname 设置交换机的主机名 router(config)#enable secret xxx 设置特权加密口令 router(config)#enable password xxb 设置特权非密口令 router(config)#line console 0 进入控制台口 router(config-line)#line vty 0 4 进入虚拟终端 router(config-line)#login 要求口令验证 router(config-line)#password xx 设置登录口令xx router(config)#(Ctrl+z) 返回特权模式 router#exit 返回命令 路由器配置 router(config)#int s0/0 进入Serail接口 router(config-if)#no shutdown 激活当前接口 router(config-if)#clock rate 64000 设置同步时钟 router(config-if)#ip address 设置IP地址 router(config-if)#ip address second 设置第二个IP router(config-if)#int f0/0.1 进入子接口 router(config-subif.1)#ip address 设置子接口IP router(config-subif.1)#encapsulation dot1q 绑定vlan中继协议 router(config)#config-register 0x2142 跳过配置文件 router(config)#config-register 0x2102 正常使用配置文件 router#reload 重新引导 路由器文件操作 router#copy running-config startup-config 保存配置 router#copy running-config tftp 保存配置到tftp router#copy startup-config tftp 开机配置存到tftp router#copy tftp flash: 下传文件到flash router#copy tftp startup-config 下载配置文件 |
|