Cisco胖ap 2.4G和5G双SSID设置 | 千月

配置方法很简单，建立两个不同的ssid，然后分别调用在Dot11Radio0和Dot11Radio1即可，废话不说，贴配置

配置

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73

dot11 ssid Cisco-5G-fat    authentication open    authentication key-management wpa version 2    guest-mode    wpa-psk ascii 7 091D1C50485743455A5D50 ! dot11 ssid Cisco-2.4G-fat    authentication open    authentication key-management wpa version 2    guest-mode    wpa-psk ascii 7 101F5B405445465C5D557E ! ! ! no ipv6 cef ! !         username Cisco privilege 15 password 7 112A1016141D ! ! bridge irb ! ! ! interface Dot11Radio0 no ip address ! encryption mode ciphers aes-ccm ! ssid Cisco-2.4G-fat ! antenna gain 0 station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding !         interface Dot11Radio1 no ip address ! encryption mode ciphers aes-ccm ! ssid Cisco-5G-fat ! antenna gain 0 peakdetect dfs band 3 block channel dfs station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface GigabitEthernet0 no ip address duplex auto speed auto bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning ! interface BVI1 mac-address ccef.488c.fd30 ip address dhcp client-id GigabitEthernet0 ipv6 address dhcp ipv6 address autoconfig ipv6 enable

 

---

iqianyue , 版权所有丨如未注明 , 均为原创，转载请注明iqianyue！

 

喜欢 (0)赏分享 (0)