The Best Strength Exercisefor CyclistsBY JASON SUMNERThis modified deadlift, from the creator of the Maximum Overload program, will make you crazy strong, and put less stress on your back than the traditional version Illustration by @bicyclingdesign The dumbbell deadlift—which closely replicates the biomechanics of pedaling—is coach Jacques DeVore’s number one strength exercise in his five-part Maximum Overload program (published by Rodale). Lifting heavy weights from a dead stop makes you crazy strong, and it eliminates the rubber-band effect (in squats and other exercises) that helps you bounce back up. This variation of the deadlift works your glutes, quads, hamstrings, and lower back, and causes less stress on your back because you don’t have to clear your knees as you would with a straight bar (a hex bar works too, though an unweighted one is 60 pounds, so you won’t use it until you can deadlift that much with proper form). Get Low Illustration by @bicyclingdesign To perform this exercise, you’ll need two dumbbells (scroll down for a guide to choosing the proper weight) or a hex bar. Lower your hips to pick up the weights or bar from the floor. Look forward, with your head and chin slightly tucked into your chest (DeVore calls it “packing the neck”), and keep your chest up. If your shirt has a logo, someone should be able to read it while standing in front of you. Get Up Illustration by @bicyclingdesign Drive your heels and midfeet into the floor as you rise, straightening your hips and knees. Pretend there is a wall in front of you that you don’t want your knees to touch, which will force you to push your hips back. Keep your back and arms straight. Stand tall at the finish. Get Down Illustration by @bicyclingdesign Reverse the motion and slowly lower the weights back down. If you’re lifting less than 60 pounds, lower until the weights are at about mid-shin. Otherwise, lower them to the ground. Do three sets of increasing weight at the maximum you can lift at 10, then 6, then 3 reps. For example: 10 reps at 30 pounds, 6 reps at 40 pounds, 3 reps at 50 pounds. (Find your weights for each set using the guide below.) Rest for three to five minutes between sets. Do this move as part of a comprehensive strength-training program like Maximum Overload two or three times a week during the off-season and once a week or twice a month when you’re riding a lot. FIND YOUR MAXIMUM WEIGHTS Do 10 deadlifts with a 10-pound dumbbell in each hand. If the last one was not a struggle (it won’t be for most), repeat with 15-pound dumbbells. If you can maintain form and pace for eight to 10 reps, go to 20-pound dumbbells, then to 25, then to 30 or an unweighted, 60-pound hex bar. Once you can’t do eight to 10 reps without a struggle, you’ve found your 10-rep weight. Repeat this process to find your six-rep weight, but start with more weight than your 10-rep amount. (For example, if you got to 20-pound weights in each hand for 10 reps, start with 25 this time.) Once you can’t do five or six reps without a struggle, you’ve found your max weight for 6 reps. Repeat similarly to find your three-rep max. Continue to add weight as you get stronger, but never increase more than 10 percent from one session to the next. |
|
|
