Toyota 4Runner: Accessory meter light controlToyota 4Runner Owners Manual / When driving / Instrument cluster / Accessory meter / Accessory meter light control The daytime brightness of the accessory meter can be adjusted.
Vehicles without Multi-terrain Select
Vehicles with Multi-terrain Select
When the average fuel consumption is reset The average fuel consumption displayed on the instrument cluster and “Past Record” screen of the Display Audio system (if equipped) or the navigation system (if equipped) will be reset at the same time. Adjusting the brightness of the accessory meter · If left idle for approximately 6 seconds or more while adjusting, the display will revert to the trip information display. · When the parking lights are on, the brightness of the accessory meter can be adjusted only with the instrument panel light control. · If the “MODE/ Liquid crystal display Small spots or light spots may appear on the display. This phenomenon is characteristic of liquid crystal displays, and there is no problem with continuing to use the display. NOTICE The accessory meter at low temperatures Allow the interior of the vehicle to warm up before using the liquid crystal display. At extremely low temperatures, the display monitor may respond slowly, and display changes may be delayed. 丰田4Runner：辅助仪表灯控制 Toyota 4Runner车主手册/驾驶时/仪表盘/附件仪表/附件仪表灯控制 附件表的白天亮度可以调节。 关闭大灯开关。 按住“ MODE / ”按钮。 按“ MODE / ”或“ SET / ”按钮。 没有多地形选择的车辆 具有多地形选择的车辆 按住“ SET / ”按钮。 重置平均油耗时 组合仪表和显示音频系统（如果配备）或导航系统（如果配备）的“过去记录”屏幕上显示的平均油耗将同时重置。 调整配件表的亮度 ·如果在调节时闲置约6秒钟或更长时间，则显示将返回到行程信息显示。 ·停车灯点亮时，只能使用仪表盘灯光控制来调节附件仪表的亮度。 ·如果按下“ MODE /”按钮 并在显示附件仪表灯控制时保持不动，显示屏将切换为指南针校准。 液晶显示器 显示屏上可能会出现小斑点或亮点。这种现象是液晶显示器的特征，并且继续使用显示器没有问题。 注意 低温附件仪表 在使用液晶显示器之前，请先对车内进行预热。 在极低的温度下，显示监视器可能响应缓慢，并且显示更改可能会延迟。
Thank you very much for watching 非常感谢您的收看 华登（walden） |
|
|
来自： 華登 > 《4Runner Trd off road》
Turn the headlight switch off.
Press and hold the “MODE/
” button.
Press the “MODE/
” button.
Press and hold the “SET/
” button is pressed
