As the steps are a little bit tricky, I use the working UI component SMCOV and SMCCMBO to illustrate. Step1: The navigation link of SMCCMBO is triggered, navigation link 2ADDDOC: So define the similar navigation link with EXACTLY the NAME 2ADDDOC in your own wrapper component like SMCCMBO: Since the navigation target is SMCCMBO/MainWindow, its inbound plug 2ADDDOC will be called: Step2: You should implement the inbound plug like below: the outbound plug should be implemented like below, use exactly the name TODOC_ADDDOC. Then define the navigation link TODOC_ADDDOC in your UI component which holds overview page, in my case, SMCOV. Note: DO NOT define it in your wrapper component ( SMCCMBO) !! Step3: Now inbound plug ADDDOC of SMCCMBO/DetailWindow will be called: So you should implement the inbound plug IP_ADDDOC as below: Also implement the outbound plug OP_TO_ADDDOC in detail window as below, use exactly the name TO_ADDDOC in line 3. This means you should define the navigation link TO_ADDDOC in wrapper component SMCCMBO. Now the navigation target is AttachmentProperty.MainWindow, inbound plug 2ADDDOC. Step4: Actually our development finished till step3. From this step, the execution is within Content management's code. Here we can observe the navigation link NL_2ADDDOC finally points to advanced page. |
|