奥的斯LCB2板 模式及输入输出信号注解

1、Operational Modes

Mode	Description	Remark
ACP	Anti Crime Protection	防犯罪保护
ANS	Anti Nuisance Service	防捣乱
ARD	Automatic Return Device	自动返基站
ARO	Automatic Rescue Operation	自动救援装置
ATT	ATTendend service	司机
CHC	Cut off Hall Call	取消外呼
COR	COrrection Run	寻址
CTL	Car To Landing	轿厢至特定楼层
DBF	Drive / Break Fault	DBSS故障
DCP	Delayed Car Protection	延迟轿厢保护
DCS	Door Check Sequence	检查门顺序
DHB	Door Hold Button mode	门保持按钮
DLM	Door Lock Monitoring	门锁监控
DTC	Door Time protection Close	关门保护时间
DTO	Door Time protection Open	开门保护时间
EFO	Emergency Fireman's Operation	紧急消防操作
EFS	Emergency Fireman's Service	紧急消防服务
EHS	Emergency Hospital Service	紧急医院服务
EPC	Emergency Power wait for Correction run	紧急电源呼叫,等待救援运行
EPR	Emergency Power Rescue run	紧急电源救援
EPW	Emergency Power Wait for normal	紧急电源等待
EQO	Earth Quake Operation	地震操作
ESB	Emergency Stop Button resp. J-Relay fault	急停按钮或相序继电器故障
GCB	General Control of Buttons	群控按钮
HAD	Hoistway Access Detection	井道过程检测
IDL	IDLe	等待
INI	INItialize	系统初始化
INS	INSpection	检修
ISC	Independent ServiCe	独立服务
LNS	Load Non Stop service	满载直驶
MIT	Moderate Incoming Traffic	中度载客
NAV	Not AVailable	轿厢不可用
OR	NORmal	正常运行
OLD	OverLoad Device	超载
PKS	ParKNing Switch	驻停开关
PRK	PaRKing	驻停
ROT	car RiOT operation	乱操作
SHO	SHabat Operation
WCO	Wild Car Operation	大厅呼叫失败

2、Motion States

State	Description	Remark
CR	Correction Run	寻址
FR	Fast Run	快速运行
ID	IDle	等待
IN	INspection Run	检修运行
NR	Not Ready	系统故障
RS	ReScue Run	救援运行
SR	Slow Run	慢速运行
ST	STop	停止

3、System Inputs系统输入

以下内容为所有的输入 信号及这些信号所处的条件
The following list shows all available inputs and the condition under which these inputs are displayed (set DISP-ALL=1 to view all available inputs).

input	group	Description	is displayed when ...
ES	Safety Chain	Emergency Stop switch	急停开关
DW		door open contact	开门触点
DFC		Door Fully Closed contact	门完全关闭触点
SE	Start Enable	Start Enable	再平层电路检查
1TH		Thermal contact 1	温控开关1
2TH		Thermal contact 2	温控开关2
TCI	Inspection	Top of Car Inspection switch	检修开关
UIB		Up Inspection Button	上检修按钮
DIB		Down Inspection Button	下检修按钮
ERO		Emergency Recall Operation switch	机房紧急操作
TDO		Top of Car Door Open Button	轿顶开门按钮
TDC		Top of Car Door Close Button	轿顶关门按钮
^TDO		rear Top of Car Door Open Button	后门轿顶开门按钮
^TDC		rear Top of Car Door Close Button	后门轿顶开门按钮
TCB		Top of Car Inspection Button (TCIB)	检修公共按钮
DZ	Doorzone	Door Zone (LV1 and/or LV2)	门区开关
1LV		Door Zone switch 1LV	门区开关1
2LV		Door Zone switch 2LV	DZ-TYP¹0门区开关2
1LS	Limit Switches	Limit Switch 1	上限位开关
2LS		Limit Switch 2	下限位开关
BY	Drive	BY-Relay	抱闸继电器
BRK		BR-Relay	抱闸检测开关
LWO	Load Weighing	overload signal LWO	超载信号
LWX		load weighing bypass LWX	称重开关
LNS		Load Non Stop	满载直驶
L30		30% load in car	LW-TYP = 2轿厢有30%负载
L50		50% load in car	LW-TYP = 2轿厢有50%负载
dol	Front Door	Door Open Limit switch	开门到位
dcl		Door Close Limit switch	关门到位
DOB		Door Open Button	开门按钮
DCB		Door Close Button	关门按钮
EDP		Electronic Door Protection	电子门保护
LRD		Light Ray Device	光幕装置
DOS		Door Open Signal	开门信号
MDD		Moving at front of Door Detection	前门检测正在运行
^dol	Rear Door	rear Door Open Limit switch	后门开门到位

^dcl		rear Door Close Limit switch	后门关门到位
^DOB		rear Door Open Button	后门开门按钮
^DCB		rear Door Close Button	后门关门按钮
^EDP		rear Electronic Door Protection	后门电子门保护
^LRD		rear Light Ray Device	后门光幕装置
^DOS		rear Door Open Signal	后门开门信号
^MDD		Moving at rear of  Door Detection	后门检测正在运行
CCT	Switches	Car Call to Top	呼梯到顶楼
CCB		Car Call to Bottom	呼梯到底楼
CHC		Cut off Hall Call	取消外呼
ddo		Disable Door Operation	禁止门操作
RTB		Remote Tripping Button
RRB		Remote Resetting Button	复位按钮
efo	Emergency	Emergency Firemen Operation	紧急消防操作
HTS		Hall Temperature Sensor from SPB	来自SPB板的温度检测
aef		Alternative EFO (AEFO)	可选的紧急消防操作
EFK		Emergency Fireman Key	紧急救援开关
ASL		Alternative Service Landing	可选的服务楼层
ESK		Emergency Service Key switch	紧急服务开关
ESH		Emergency Service Hold switch	紧急服务保持开关
CFS		Car Fireman Service switch (Australia)	轿厢紧急消防服务开关
CS		Car fireman service Start switch (Australia)	轿厢紧急消防开始开关
xef		Overide EFO	覆盖EFO
EFB		Emergency Firemen Key Bypass (EFKB)
nu	Emerg. Power	emergency power operation signal	EPO-P<=32紧急电源服务
nud		emergency power operation signal	EPO-P<=32紧急电源服务
nug		emergency power operation signal	EPO-P<=32紧急电源服务
NRF		NURF	EPO-P<=32紧急电源服务
ISS	OCSS	Independent Service Switch	独立服务开关
^ISS		rear Independent Service Switch	后门服务开关
pdd		Partition Door Device Switch	隔离门装置开关
CTL		Car To Lobby	CTL-P<=31轿厢至大厅
PKS		ParKing Switch	PKS-P<=31驻停开关
coc	Cut/Disable	Car call cut Off (Car)	取消轿厢呼梯
coh		Car call cut Off (Hall)	取消大厅呼梯
hco		hall call Cut Off (Hall)	取消大厅呼梯
gco		hall call Cut Off (Group)	取消大厅呼梯(群控)
DFD		Disable Front Door	禁止前门操作
DRD		Disable Rear Door	禁止后门操作
CRC		Card Reader Contact	EN-CRO¹0读卡器触点
BOS		BOSs card reader overwrite	EN-CRO¹0读卡器重写
ATU	Attendant	Attendant key Up	司机上行按钮
ATD		Attendant key Down	司机下行按钮
NSB		Non Stop Button	直驶按钮
RB		Reset Button	复位按钮
UM1	reduced hwy	i/o 1047 TUM1	HW-TYP = 1 or 3

UM2		i/o 1048 TUM2	HW-TYP = 1 or 3
UMP		i/o 1050 TUPS	HW-TYP = 1 or 3
OSU		i/o 1054 SOSU	HW-TYP = 1 or 3
DM		i/o 1049 TDM	HW-TYP = 2 or 3
DP		i/o 1051 TDPS	HW-TYP = 2 or 3
OSD		i/o 1055 SOSD	HW-TYP = 2 or 3

4、System Outputs系统输出

output	group	Description	is displayed when ...
1RT	Tripping	Remote Tripping  for car	遥控正常
1RR		Remote Resetting  for car	遥控复位
3RT		Remote Tripping  for counterweigt
LVC	Door Bypass	LVC-Relay	LVC继电器
SFR		Safe To Relevel (door bypass active and no demand to run)	安全再平层
DFR	OCSS	DFC-Relay	门完全关好继电器
PDR		Power Down Relay (Power Save Mode)	节能模式
LR		Light Relay	灯继电器
NUD	Emergency		紧急
NUG
BUT	REM	BUTton operated (any demand to move)	按钮已经操作
DO		Door fully Opened	门完全打开
NORM		NORMal operation (no faults)	正常运行
CPR		Car PaRked, waiting for demand	等待运行指令
MF		Main Floor (lobby)	主楼层(大厅)
LND		LaNDing passing	正经过楼层
OOS		Out Of Service	脱离服务
LEV		LEVel signal	平层信号
DC		Door Close Command	关门命令
RFS		Request For Service	要求服务
SPB		Service Panel Board Fault	SPB板故障
SCS		Slack Belt Contact Switch	段带开关触点
HTS		Hall Temperature Sensor on SPB	大厅温度传感器
RDO		Rear Door Open Signal	后门开门信号
RDC		Rear Door Close Signal	后门关门信号
BRK		Brake Signal from Drive	来至驱动的抱闸信号
SAF		Safety Chain (ES)	安全回路
DS		Door Switch (with DBP: DW, w/o DBP: DFC)	门触点
CLM		Car Light Monitoring	轿厢照明监控