|
36.2.6 C- Is there evidence that maximum length of tie wrap ends has not been exceeded after cutting, in accordance with procedures?YES/NO 37.ELECTRICAL SHIELDING SECTION NA 37.1 Braided (Metal) SECTION NA 37.1.1 P- Is there a procedure for application of braided shield to a cable or wire harness assembly?YES/NO 37.1.2 P- Is there a procedure that ensures a separator (e.g. Tape) between the cable/harness and the braid to protect the cable/harness from potential damage?YES/NO 37.1.3 P- Is there a procedure to remove temporary holding devices prior to braiding?YES/NO 37.1.4 P- Is there a procedure for acceptance criteria for braided shielding?YES/NO 37.1.5 C- Is there evidence that cable and wire harness assemblies have been shielded with braids in accordance with procedures?YES/NO 37.1.6 C- Is there evidence that separators are used between the cable / harness and the braid to protect the cable / harness from potential damage?YES/NO 37.1.7 C- Is there evidence that temporary holding devices are removed prior to braiding? YES/NO 37.1.8 C- Is there evidence that acceptance criteria for braided shielding is available and being followed?YES/NO 37.1.9 Braided (Metal) Direct Applied SECTION NA |
|
|
